|
|
|
P A I N T I N G & P A P E R I N G
|
|
T I L I N G
|
Minimum 9mm thick boards
should fixed, textured side out. Supports
should be maximum 400mm centres with cross
noggins at transverse board joints. Seal the boards with PVA
(Poly Vinyl Acetate adhesive).
Countersunk corrosion resistant screws should be used to fix boards at 200mm centres. Fix
tiles in strict accordance with
manufacturers’ recommendations. |
 |
|
|
Any conventional paint can be used. Alkali resistant primers are not
necessary for water based paints but are recommended for oil based paints.
Water based paints (with a watered down first coat) or oil
based paints can be applied to all products using proprietary
primer/top coat systems as recommended by paint manufacturers.
When papering MASTERBOARD®, size
with diluted adhesive to seal against suction and
improve slip, then hang papers or vinyl in the
normal manner.
|
|
P L A S T E R I N G
|
|
If a skim finish is desired, fix textured side out, apply a sealing coat
of universal primer and allow to dry. Follow with a second coat.
Apply plaster while this coat is wet and tacky. At all times strictly
follow plaster/jointing compound manufacturers’ instructions for
applying to fibre cement boards.
|
|
|
60mm thick x 20 kg/m3 mineral wool
(optional) |
|
Mineral wool padding underneath
(optional) |
|
50mm x 63mm softwood timber studs
at 610mm centres |
|
Minimum 50mm x 63mm softwood
horizontal timber at 2440mm centres |
|
38mm long nails at 200mm centres or
25mm screws at 300mm centres |
|
Non combustible fixings at nominal
500mm centres |
|
60mm thick x 23 kg/m3 mineral wool (optional) |
|
35mm x 48mm x 35mm x 0.5mm thick
vertical steel studs at 610mm centres |
|
No.8 self-tapping screws at 300mm centres |
|
Steel channel section fixed to substrate
using non combustible fixings at nominal
500mm centres. |
|
Click
for other
