Intumex Asia Pacific

Where Fire Stops

Partition

Other

Intumex

Products

Fire Stopping

Also look:
Etex Group

SUPALUX^® - Partitions

SUPALUX^® partitions provide periods of fire resistance from 30 minutes up to 240 minutes, depending on the specification. Our design capabilities allow us to offer a range of lightweight and slim line partition systems. Lighter weight partition systems reduce floor loading, whilst still maintaining performance. The use of slim line construction is particularly advantageous in commercial property development where developers are able to maximise revenue through increasing the net lettable area of the property.

*For more detail, roll your cursor over the individual numerals in the three drawings below.

63mm x 50mm perimeter timber

Minimum 60mm thick x 34kg/m³ density mineral wool between studs (omitted here for clarity)

63mm x 50mm timber studs at 610mm centres

63mm x 50mm horizontal timber noggings at board joints

9mm thick SUPALUX^® board

560mm (from A to B)

2440mm (from B to C)

1220mm (from D to E)

48mm x 35mm x 0.5mm thick steel channel

60mm thick 23kg/m³ density mineral wool

75mm wide x 9mm thick SUPALUX^® cover strip, behind horizontal joints fixed on both sides of the joint with 19mm long No.8 self-tapping screws at 300mm centres

48mm x 35mm x 0.5mm thick steel channel studs at 610mm centres

9mm thick SUPALUX^® board fixed to channels using 19mm long No.8 self-tapping screws at 300mm centres

610mm (from A to B)

Balance (B to C)

2440mm (from C to D)

15mm thick SUPALUX^® board fixed to 20mm thick board using 30mm long 4.5mm diameter self-tapping screws at 300mm centres

20mm thick SUPALUX^® board fixed to perimeter angle using 30mm long 4.5mm diameter self-tapping screws at 300mm centres

30mm x 30mm x 0.6mm thick perimeter angle fixed to concrete using M6 bolts at 400mm centres compressing a strip of 65mm wide x 10mm thick mineral wool between them to act as a smoke seal gasket on uneven substrates

610mm (from A to B)

610mm (from B to C)

610mm (from C to D)

1220mm (from D to E)

3000mm (from E to F)

30 minute fire rated SUPALUX^® timber stud partition

NOTES:

Boards to timber: 50mm long clout or wire nails at 300mm centres

Timber to timber: 75mm long skewed nails

Timber to masonry: M6 screw and plugs at 500mm centres

Provide mineral wool strips between perimeter timber and masonry where uneven surfaces exist.

60 minute fire rated SUPALUX^® steel stud partition

NOTES:

Please consult Intumex Asia Pacific for the following:

Constructions offering periods of protection from 30 to 240 minute integrity and insulation, or for loadbearing partitions.

Details of local requirements for minimum mineral wool thickness and density.

60 minute fire rated SUPALUX^® solid partition

NOTES:

Screw fixings to perimeter angles shall be 15mm from the board edge and at 200mm centres.

Screw fixings board to boards shall be at 200mm centres and consist of course thread stitching screws.

Where required for aesthetic purposes, all screw heads shall be finished with gypsum jointing filler. not required for fire resistance purposes.